| Dry Application Instructions for LG Decals (over 10"): You will need: 1 squeegee or credit card Application fluid or water with liquid soap mixed in Masking Tape Paper towels or other cloth |
To Start:
-Pull the decal out of the shipping package.
wrinkles, (Large decals may be rolled for shipping), if your decal was rolled follow
the previous steps and allow to lay flat for approx 1hr. Also work out any bubbles
you may see.
-Clean off the surface where you plan to install your decal using a detergent based
cleaner, you can also use a rubbing alcohol, we recommend this anyway as a sure
way to remove all wax and other oil based products from the surface. DO NOT
USE AMMONIA BASED CLEANERS SUCH AS WINDEX, they will out gas for a few
weeks and may cause your decal to peel or bubble.
-Pull the decal out of the shipping package.
wrinkles, (Large decals may be rolled for shipping), if your decal was rolled follow
the previous steps and allow to lay flat for approx 1hr. Also work out any bubbles
you may see.
-Clean off the surface where you plan to install your decal using a detergent based
cleaner, you can also use a rubbing alcohol, we recommend this anyway as a sure
way to remove all wax and other oil based products from the surface. DO NOT
USE AMMONIA BASED CLEANERS SUCH AS WINDEX, they will out gas for a few
weeks and may cause your decal to peel or bubble.
1) Place the decal where you want it. Without
removing the backing or application tape apply
masking tape to the middle of your decal
creating a hinge.
removing the backing or application tape apply
masking tape to the middle of your decal
creating a hinge.
2) Starting from either end, pull the backing
paper off up to the masking tape strip. Either
tear the backing paper off or use scissors or a
knife to cut and remove it.
paper off up to the masking tape strip. Either
tear the backing paper off or use scissors or a
knife to cut and remove it.
3) Carefully squeegee the decal from the
middle, where the masking tape is to the end.
middle, where the masking tape is to the end.
4) Now that one half of your decal is secure,
remove the masking tape. Now remove the
other half of the wax backing.
remove the masking tape. Now remove the
other half of the wax backing.
5) Carefully squeegee the second half starting
from the middle and working towards the end.
from the middle and working towards the end.
6) Visually inspect for any bubbles and
squeegee them out.
squeegee them out.
7) Finally, gently remove the application tape by
starting in a corner, pull (gently) in the opposite
direction of the corner you started with. (If you start
with the top left corner pull to the right). This
reduces the tension on the vinyl itself and
keeps the tension on the tape.
starting in a corner, pull (gently) in the opposite
direction of the corner you started with. (If you start
with the top left corner pull to the right). This
reduces the tension on the vinyl itself and
keeps the tension on the tape.
Use your fingers to press down on corners or small flares. If
by chance there are air bubbles, do not worry, you can use a
small needle and poke the bubble, don't worry about the hole,
the vinyl will seal the hole after 24 hrs, and work out the air
through the small hole.
by chance there are air bubbles, do not worry, you can use a
small needle and poke the bubble, don't worry about the hole,
the vinyl will seal the hole after 24 hrs, and work out the air
through the small hole.
| ENJOY YOUR NEW DECAL!! |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
